ZEROSIL

Silicone Remover

FILA ZEROSIL is a remover developed to eliminate residues of silicone, resin, adhesive, wax, adhesive tape, old labels and polyurethane foam from porcelain tiles, ceramic tiles, marble, glass and metal surfaces. In addition to general oil and grease stains, it is also effective in removing marks of tar, bitumen and polyurethane adhesive.

Its dense consistency acts directly on the targeted residue, increasing effectiveness and preventing unnecessary consumption. Its fast-acting formula dissolves hardened silicone in 20 minutes; thanks to the spatula supplied, the dissolved residues are scraped off quickly and easily. It can also be used on marble, stone, grout and other absorbent materials to remove surface residues. Ready to use, ZEROSIL requires no dilution and has a pleasant citrus scent.

Texture Request WhatsApp: ZEROSIL

Product Character

Key Features

Fast-acting: dissolves hardened silicone in 20 minutes.
Its dense consistency acts directly on the targeted residue; prevents unnecessary consumption.
Quick and easy to apply thanks to the spatula supplied.
Can also be used on marble, stone, grout and other absorbent materials.
Also effective in removing marks of polyurethane adhesive, tar and bitumen.
Pleasant citrus scent.

Suitable Surfaces

Areas of Use

Porcelain and ceramic tiles
Marble and stone surfaces
Glass surfaces
Metal surfaces
Grout and other absorbent materials

5-Step Application

Application

Cut Away Excess Residue

If the residue is very stubborn, remove as much of it as possible with a sharp-edged tool (utility knife, knife, etc.), taking care not to damage the surface.
Apply the Product

Shake before use. Apply the product undiluted so that it covers all of the silicone residue.
Wait

Allow it to act for approximately 20 minutes.
Scrape and Wipe

Scrape off the dissolved residue with the spatula supplied, then remove it with a cloth or paper towel. If necessary, repeat the application and leave it on for longer.
Clean the Spatula

After use, clean the spatula thoroughly with a cloth or paper towel.

Safe Use

Points to Consider

To use the product safely and at maximum efficiency, please read the following points carefully before application.

The product may cause dulling on methacrylate, plastic and coated surfaces and on resin-based agglomerates; a test must first be carried out to check the resistance of these surfaces.
If the treated surface has previously been waxed, the wax must be renewed.
When pre-cleaning with a sharp-edged tool, take care not to damage the surface.
Keep out of the reach of children.
Do not release into the environment after use.
Storage: 0-30 °C; surface during application: 5-30 °C.