ULTRASHINE FLOOR

Professional Crystallising Polish

FILA ULTRASHINE FLOOR is a professional crystallising polish developed to restore the shine of worn surfaces. It is ideal for crystallising polished limestone-based surfaces (marble, travertine) and polished agglomerate stone such as terrazzo, traditional Palladiana and Venetian terrazzo. Based on the average value obtained in laboratory tests, it quickly restores more than 90% of the original shine of the surface.

It keeps surfaces shiny for a long time and increases their resistance to wear caused by foot traffic. Depending on the initial condition of the material, it offers a high coverage of 50-70 m² per 1 litre. The application can be repeated over the entire surface or only on specific areas. Applied with an airless pump and a single-disc floor machine fitted with a stainless steel wool pad, ULTRASHINE FLOOR is for professional use only.

Texture Request WhatsApp: ULTRASHINE FLOOR

Product Character

Key Features

Quickly restores more than 90% of the original shine of the surface (average value obtained in laboratory tests).
High coverage: 50-70 m² per 1 litre, depending on the initial condition of the material.
Keeps surfaces shiny for a long time and increases their resistance to foot traffic.
The application can be repeated over the entire surface or on specific areas.

Suitable Surfaces

Areas of Use

Polished marble
Polished travertine and limestone-based surfaces
Polished agglomerate stone (terrazzo, Palladiana and Venetian terrazzo)

4-Step Application

Application

Prepare the Surface

Make sure the surface is clean and dry, free from dirt, dust and wax residues. The product is ready to use; shake before use.
Spray

Using an airless pump, spray a measured amount of ULTRASHINE FLOOR onto a small area (maximum 2 m²).
Spread with the Machine

Immediately afterwards, spread the product evenly with a single-disc floor machine fitted with a stainless steel wool pad; continue until the product is completely dry and the desired shine is achieved. Repeat the same process on the remaining parts of the surface.
Remove the Fibres

Remove the steel wool fibres by wiping the surface with a microfibre cloth or a dry microfibre mop. To even out the shine and remove application marks, buffing the surface with a white pad is recommended.

Safe Use

Points to Consider

To use the product safely and at maximum efficiency, please read the following points carefully before application.

For professional use only.
Do not use on surfaces that are not limestone-based, such as granite, quartzite or sandstone in general.
Avoid contact with materials such as wood, terracotta, ceramics and metal (steel and aluminium profiles).
Do not leave puddles on the surface and do not allow the product to drip from the container onto the surface.
Carry out a preliminary test on a small area to check the effect of the application.
Wait at least 24 hours before wetting the floor.
Keep out of the reach of children; do not discharge the product into the environment after use.
Storage: 5-30 °C; surface during application: 10-30 °C.